Using Multiple Handsets; Registering Handsets - Gigaset S910 User Manual

Deactivating the wake-up call/
repeating after a pause (snooze
mode)
Prerequisite: A wake-up call is sounding.
§Off§
Press the display key. The wake-
up call is deactivated.
or
§Snooze§
Press the display key or any key.
The wake-up call is deactivated
and then repeated after 5 min-
utes. After the second repetition
the wake-up call is deactivated
for 24 hours.

Using multiple handsets

Registering handsets

You can register up to six handsets to your
base.
A Gigaset S910H handset can be registered
on up to four bases.
Manually registering a
Gigaset S910H to a Gigaset S910/
S910A
You must activate manual registration of the
handset on both the handset (1) and the
base (2).
When the registration process has com-
pleted successfully, the handset returns to
idle status. The handset's internal number is
Using multiple handsets
shown in the display e.g., INT 1. If not, repeat
the procedure.
1) On the handset
The handset is not registered to a base.
§Register§
Press the display key.
The handset is already registered to a base:
Ï
v ¢
¢ Registration
¢ Register Handset
If the handset is already registered to four
bases:
s
Select base, e.g., Base 3 and
§OK§
press
~
If required, enter the system
PIN for the base and press
A message appears stating that the hand-
set is searching for a base that is ready for
registration.
2) On the base
Within 60 seconds press and hold the reg-
istration/paging key on the base
(¢ page 4) (approx. 3 seconds).
Registering other handsets
You can register other Gigaset handsets and
handsets for other devices with GAP func-
tionality as follows. .
1) On the handset
Start to register the handset as described
in its user guide.
2) On the base
Press and hold the registration/paging key
on the base (¢ page 4) (approx. 3 sec.).
.
§OK§
49
.