[Multi-Screen Setup] Screen - Panasonic AK-UB300G Operating Instructions Manual

Item
[Unicast port1 (Image)]
[Multicast address]
[Multicast port]
[Multicast TTL/HOP Limit]

[Multi-screen setup] screen

[Multi-screen setup] screen sets the camera to display in the multi-screen.
Chapter 6 Web Screen — [Setup] screen
Sets the unicast port number (to be used when images are transmitted from the camera).
This item must be configured when [Transmission type] is set to [Unicast port (MANUAL)].
[1024] - [50000]
Only even numbers can be configured.
10670 cannot be set as a port number.
f Factory setting: [32004] ([H.264(1)]), [32014] ([H.264(2)]), [32024] ([H.264(3)]), [32034] ([H.264(4)])
Sets the IP address of the multicast.
The images are transmitted to the specified IP address.
This item must be configured when [Transmission type] is set to [Multicast port].
Before setting, check if it can be used as a multicast IP address.
[224.0.0.0] - [239.255.255.255]
f Factory setting: [239.192.0.20] ([H.264(1)]), [239.192.0.21] ([H.264(2)]), [239.192.0.22] ([H.264(3)]),
[239.192.0.23] ([H.264(4)])
Enter the multicast port number (to be used when images are transmitted from the camera).
This item must be configured when [Transmission type] is set to [Multicast port].
Only even numbers can be configured.
10670 cannot be set as a port number.
[1024] - [50000]
f Factory setting: [37004]
Enter the TTL/HOP Limit value of the multicast.
This item must be configured when [Transmission type] is set to [Multicast port].
[1] - [254]
f Factory setting: [16]
When H.264 images are transmitted via Internet, the transmitted images may not be displayed depending
on the settings for the proxy server, firewall, etc. In this case, consult your network administrator.
When multicast images are to be displayed using a computer where multiple LAN cards are installed,
disable the LAN cards that are not to be used for reception.
– 83 –
Description of settings