Closing The Housing - Ikelite 200DL Manual

Hotshoe must be all the way forward in the camera mount to
»
ensure a good electrical connection.

Closing the Housing

1. Make sure the o-ring is clean and in its proper location on the back
of the housing. The main housing o-ring does not require lubricant
to make a seal.
2. Place the back onto the housing front.
3. Make sure no controls or wires are interfering with the o-ring or the
back of the housing.
4. Place each lid snap into the corresponding hook on the housing
back.
5. Push the lid snaps toward the housing until they are flat against the
housing and the lock has engaged. Close opposing lid snaps at the
same time.
14
Hotshoe
Hotshoe Mount