Attaching A Sync Cord - Ikelite 200DL Manual

•
CT1K Canon TTL Kit # 46070
•
Sync Cord # 4103.51 (single) or 4103.52 (dual)
•
Compatible Ikelite DS strobe(s)
SEA&SEA, INON, Nikonos, and Ikelite non-DS strobes are
»
not capable of powering or interacting with the Canon TTL
Converter. These strobes may be attached via sync cord and
used in manual strobe power settings.

Attaching a Sync Cord

A bulkhead cap or sync cord must be attached to the housing
»
for waterproof operation. Never submerge the housing without
either a sync cord or waterproof bulkhead cap attached.
1. Remove the bulkhead cap.
2. Lightly lubricate the sync cord o-rings. We recommend using only
Ikelite silicone lubricant to eliminate the possibility of swelling due to
incompatible compounds.
3. Line up the pins and receptacles and insert the sync cord plug into
the housing bulkhead.
Waterproof
Bulkhead Cap
Retaining
Ring
Bulkhead
4. Rotate the knurled retaining ring until snug on the housing
bulkhead. Do not use pliers or tools to tighten the retaining ring.
Retaining
Ring
O-ring
Bulkhead
21