Using The Camera's Built-In Flash; Closing The Housing - Ikelite 6184.95 Instruction Manual

Using the Camera's Built-in Flash

The camera flash will automatically extend when the shutter release is
depressed halfway and the camera is set to "Fill Flash" in the "Auto
Mode." When the camera lens is set to the widest angle setting, you
may need to zoom the lens slightly or a dark area (vignetting) may
appear in a corner(s) of your photographs. The lens port will block some
of the flash. Install the Diffuser and zoom in to eliminate any dark areas
noted in your photographs (You can test this above water). See
Diffuser/Deflector Installation - page 10. For the best results, we
recommend using an external Ikelite Substrobe.
The camera's built-in flash should NOT be used with optional Wide Angle
or Accessory lenses.

Closing the Housing

1. Place housing face down in your lap or on a flat surface.
2. Check to see that there is an o-ring on the
housing back and that it is clean, and in its
proper location.
3. Guide the back into the housing front. The
o-ring should touch the housing all the way
around. There should be an even gap all
the way around between the housing and
the housing back.
4. Lift the lid snaps so they are extended and
place each lid snap into the corresponding
hook on the housing back.
5. To close the housing, push down on the lid
snaps until they snap into place. Lid snaps
on opposite sides of the housing should be
closed at the same time. Be sure they are
down far enough to engage the lock.
8
Housing Back
Housing
Even gap on
all four sides
Housing Back
O-ring
O-ring