Closing The Housing - Ikelite 69750 Manual

3. Line the mount screw up with the camera's tripod socket. Use a flat
screwdriver to tighten the mount plate to the camera.
1/4-20 tripod
mount
4. Pull out on the housing control knobs to move the controls out of
the way.
5. Insert the mount plate into the slot on the inside bottom of the
housing. Push the camera all of the way forward until it stops.
6. Push housing control knobs in and check orientation with the
camera.
The camera may be attached to a tripod using the 1/4-20
»
threaded mounting hole on the bottom of the mount plate.

Closing the Housing

1. Make sure the o-ring is clean and in its proper location on the back
of the housing. The rear housing o-ring does not require lubricant
to make a seal.
2. Place the back onto the housing front.
3. Make sure no controls or wires are interfering with the o-ring or the
back of the housing.
12
Mount screw
Camera
tripod socket
LENS