Lens Port; Storage - Ikelite 200DL Manual

5. Always re-check o-ring seals after opening the housing or removing
the lens port.

Lens Port

Treat the surface of the lens port like a camera lens. After use, rinse
and gently dry the outside lens port to avoid water spotting. To clean,
use a mild soap solution or lens cleaner.
Do not rinse the inside of the Port.
»
Never use alcohol or window cleaner on the Lens Port.
»

Storage

Your Ikelite Digital Housing should be given the same care and
attention as your other photographic equipment. In addition to normal
maintenance, we recommend that the housing be returned to Ikelite
periodically to be checked and pressure tested.
1. Clean the housing and controls thoroughly prior to storage.
2. Remove the back and port o-rings. Lightly lubricate each o-ring until
it appears shiny. Place in a small re-sealable plastic bag inside of
the housing.
3. Leave the lid snaps open to release pressure on the lid snap
springs.
4. Disassemble and thoroughly rinse the Base with Quick Release
Handle(s) prior to storage.
5. Store the housing in a cool, dry place away from direct sunlight and
chemicals.
6. Before using the housing, check the tightness of the set screw in
each control knob. Check each control gland to make sure they are
snug. There is a slight chance that either could vibrate loose during
travel.
23