Table of Contents
Advertisement
5. Attach the other end of the sync cord to the bulkhead on your
strobe.
6. If using an Ikelite strobe, set the strobe to TTL. If using a non-Ikelite
strobe, set the strobe to manual flash and select a manual power
setting.
7. Turn on the strobe(s).
8. Turn on the camera.
9. Take a test photo to ensure that your strobe(s) are functioning
properly.
Constant-On Video Lighting
A bright constant-on video light can be used instead of or in addition
to a flash. A constant-on light is not as bright as a strobe flash.
Constant-on lights do provide added versatility because they can be
used for focus assist and for improved colors when shooting video.
Maintenance
Post-Dive
1. Rinse the housing in fresh water. Rotate the housing controls and
press each button while submerged in fresh water to flush out any
salt or debris to ensure smooth operation on future dives.
2. NEVER leave your housing in a fresh water rinse tank, even if it is
the only system in the tank. Collisions with another person's gear
can cause scratches or damage to your equipment. Accidental
floods occur most often in the rinse tank.
3. Store the housing in a shaded place where it is protected from
impact or overheating. If no shade is available, we recommend
covering the housing with a towel or cloth.
4. Check the memory card capacity and battery life of your camera
and strobe(s). Recharge as necessary.
22
Advertisement
Table of Contents
