Deleting One Or More Atm Iisp Interfaces - Lucent Technologies PacketStar PSAX User Manual

Deleting One or More ATM IISP Interfaces

®
PSAX 6-Port DS1 IMA Module User Guide, Issue 1
PacketStar
255-700-268
Chapter 4 Configuring the Interfaces Using the Console Interface
Table 4-6. Windows on Which You Can Take an IISP Interface out of Service
If the module you are working
with is:
a channelized single-port
module,
a channelized multiport
module,
The window status line prompts:
Taking the interface down will cause all SVCs to be lost.
Continue? (y/n)
2 Select Y.
The interface is taken out of service. The value OutOfService is now
displayed in the [Admin Status] and the [Oper Status] fields. If a connec-
tion is already configured for this interface, the traffic flow is stopped. To
resume traffic on the connection using this interface, you must bring the
interface back into service (see the section, "Bringing One or More ATM
IISP Interfaces into Service).
End
Begin
You can do this task from several different windows. To delete one or more
ATM UNI interfaces, perform the steps in the following procedure.
1 Make sure the interface is out of service before deleting it. See the "Tak-
ing One or More IISP Interfaces Out of Service" procedure if you need to
the take the interface out of service.
Managing ATM IISP Interfaces
you can take one or more interfaces out of
service on these windows:
• Port configuration window (all inter-
faces for all virtual ports)
• Virtual port configuration window (all
channel interfaces on a virtual port)
• Channel configuration window (just the
interface for the channel)
• IISP Interface Configuration window
(just the interface for the channel)
• Module configuration window (all inter-
faces for all ports)
• Port and channel configuration window
(all channel interfaces on a port)
• Channel configuration window (just the
interface for the channel)
• IISP Interface Configuration window
(just the interface for the channel)
Release 8.0
4-19