TANDBERG Quick Set C20/C20 Plus and Profiles using C20
Contents
Contents
Introduction
Introduction
Codec C20–The physical interface
The front panel LEDs
The LED in front of the codec indicates the status of the codec.
•
When the LED is OFF the codec is Off.
•
The LED flashes
green
during the boot up and shut down of
the codec.
•
The LED pulses
green
when the infrared (IR) port is activated.
This will occur when the remote control is in use.
•
The LED is steady
green
when the codec is On, in Standby
mode or in Presentation mode.
•
When the LED is
red
this indicates an Error has occurred.
D14637.01—MARCH 2010
Advanced configuration
Advanced configuration
Power
Call
IR
Alarm
(infrared)
Password protection
Password protection
About monitors
About monitors
37
Administrator guide
Appendices
Appendices
Appendices
Contact us
Contact us
www.tandberg.com