Table of Contents
Advertisement
TANDBERG Quick Set C20/C20 Plus and Profiles using C20
Contents
Contents
Introduction
Introduction
The Network settings,
cont...
Network [1..1] Speed
Set the ethernet link speed.
Valuespace: <Auto/10half/10full/100half/100full/1000full>
Auto: Autonegotiate link speed.
10half: Force link to 10Mbps half-duplex.
10full: Force link to 10Mbps full-duplex.
100half: Force link to 100Mbps half-duplex.
100full: Force link to 100Mbps full-duplex.
1000full: Force link to 1Gbps full-duplex.
Example:
Network 1 Speed: Auto
Network [1..1] TrafficControl Mode
Configure how video packets transmission speed shall be controlled.
Valuespace: <On/Off>
On: Transmit video packets at maximum 20Mbps. Can be used to smooth out bursts in the outgoing
network traffic.
Off: Transmit video packets at link speed.
Example:
Network 1 TrafficControl: On
D14637.01—MARCH 2010
Advanced config.
Advanced configuration
Advanced configuration
Password protection
Password protection
18
About monitors
About monitors
The Network Services settings
NetworkServices Multiway Address
Set the Multiway address equal to the Conference Factory Alias, as set up on the VCS.
Multiway™ conferencing enables video endpoint users to introduce a 3rd party into an existing call. It can
be used in the following situations:
1) When you want to add someone else in to your existing call.
2) When you are called by a 3rd party while already in a call and you want to include that person in the call.
Requirements: The TANDBERG Codec C20 must be running TC3.0 (or later), TANDBERG VCS version
X5 (or later) and TANDBERG Codian MCU version 3.1 (or later). Endpoints invited to join the Multiway™
conference must support the H.323 routeToMC facility message if in an H.323 call, or SIP REFER message
if in a SIP call.
Valuespace: <S: 0, 255>
Format: String with a maximum of 255 characters.
Example:
NetworkServices Multiway Address: "h323:multiway@company.com"
NetworkServices Multiway Protocol
Set the protocol to be used.
Valuespace: <Auto/H323/SIP>
Auto: The system will select the protocol for Multiway calls.
H323: The H323 protocol will be used for Multiway calls.
SIP: The SIP protocol will be used for Multiway calls.
Example:
NetworkServices Multiway Protocol: Auto
NetworkServices H323 Mode
Determines whether the system should be able to place and receive H.323 calls.
NOTE! Changes in this setting requires the codec to be restarted.
Valuespace: <On/Off>
On: Set to On to enable the possibility to place and receive H.323 calls.This is the default setting.
Off: Set to Off to disable the possibility to place and receive H.323 calls.
Example:
NetworkServices H323 Mode: On
Administrator guide
Appendices
Appendices
Contact us
Contact us
www.tandberg.com
Advertisement
Table of Contents
