Table of Contents
Advertisement
TANDBERG Quick Set C20/C20 Plus and Profiles using C20
Contents
Contents
Introduction
Introduction
The Conference settings,
cont...
Conference [1..1] Encryption Mode
In Point to point calls (BestEffort mode): If the far end system supports encryption (AES-128), the call will
be encrypted. If not, the call will proceed without encryption.
In MultiSite calls (BestEffort mode): In order to have encrypted MultiSite conferences, all sites must
support encryption. If not, the conference will be unencrypted.
Icons on screen: A padlock with the text "Encryption On" displays on screen, for a few seconds, when the
conference starts.
Valuespace: <Off/On/BestEffort>
BestEffort: The system will use encryption whenever possible.
On: The system will only allow calls that are encrypted.
Off: The system will not use encryption.
Example:
Conference 1 Encryption Mode: BestEffort
Conference [1..1] DefaultCall Protocol
Specify the Default Call Protocol to be used when placing calls from the system. The call protocol can also
be defined directly for each call when setting up a call.
Valuespace: <H323/SIP>
H.323: Select H.323 to ensure that calls are set up as a H.323 calls.
SIP: Select SIP to ensure that calls are set up as a SIP calls.
Example:
Conference 1 DefaultCall Protocol: H323
Conference [1..1] DefaultCall Rate
Specify the Default Call Rate to be used when placing calls from the system. The call rate can also be
defined directly for each call when setting up a call.
Valuespace: <64..6000>
Range: 64-6000 kbps
Example:
Conference 1 DefaultCall Rate: 768
D14637.01—MARCH 2010
Advanced config.
Advanced configuration
Advanced configuration
Password protection
Password protection
13
About monitors
About monitors
The Conference settings,
cont...
Conference [1..1] VideoBandwidth Mode
In "Dynamic" mode the available transmit bandwidth for the video channels is distributed among the
currently active channels. This means that the main video channels will use the bandwidth of the
presentation channel, if there is no active presentation. In "Static" mode the bandwidth is assigned to each
video channel even if it is not active.
Valuespace: <Dynamic/Static>
Dynamic: The available transmit bandwidth for the video channels are distributed among the currently
active channels.
Static: The available transmit bandwidth is assigned to each video channel, even if it is not active.
Example:
Conference 1 VideoBandwidth Mode: Dynamic
Conference [1..1] VideoBandwidth MainChannel Weight
The available transmit video bandwidth is distributed on the main channel and presentation channel
according to "MainChannel Weight" and "PresentationChannel Weight". If the main channel weight is 2
and the presentation channel weight is 1, then the main channel will use twice as much bandwidth as the
presentation channel.
Valuespace: <1..10>
Select a value between 1 and 10.
Example:
Conference 1 VideoBandwidth MainChannel Weight: 5
Conference [1..1] VideoBandwidth PresentationChannel Weight
The available transmit video bandwidth is distributed on the main channel and presentation channel
according to "MainChannel Weight" and "PresentationChannel Weight". If the main channel weight is 2
and the presentation channel weight is 1, then the main channel will use twice as much bandwidth as the
presentation channel.
Valuespace: <1..10>
Select a value between 1 and 10.
Example:
Conference 1 VideoBandwidth PresentationChannel Weight: 5
Administrator guide
Appendices
Appendices
Contact us
Contact us
www.tandberg.com
Advertisement
Table of Contents
