Preparing To Drive - Taski swingo 1250B User Manual

Maintenance of batteries (only wet batteries)
Please follow the instructions of use for your battery charger!
Caution:
When maintenance of batteries takes place, they must be
disconnected from the machine!
Opening battery compartment for maintenance
• Check that the machine has been switched off with the keyswitch.
• Disconnect the battery from the machine using the battery disconnection
socket.
• Lower the squeegee.
• Check that the tanks are empty.
• Unlock the battery compartment, by pushing a
screw driver or a similar tool into the allowed
opening.
• Lift the tank until it locates into its self support
position.
Tank position before it is altered for battery
maintenance.
• Stand behind the machine.
• Carefully open battery compartment until the
machine handle rests on the floor.
Tank position for battery maintenance.
Closing battery compartment
• Stand behind the machine and lift the tank until
it rests on the tank self support.
• Hold the tank and press the tank support
inwards.
Now lower the tank until it locates into place.
After end of maintenance
• Connect the battery to the machine with the battery disconnection socket.
• Raise the squeegee.

Preparing to drive

• Switch on the keyswitch.
The indicators light up briefly.
The battery indicator displays that the machine is
ready for operation
(on malfunction see page 29).
• Hold the handle and adjust to a height which is
comfortable to work with.
The speed controls can be moved up and down
by applying light pressure.
By lightly pressing the speed control in the
direction of drive, the machine is set in motion.
Letting the speed control go stops the machine.
Attaching tools
• Switch the machine off using the keyswitch and remove the key.
Check:
• that the brushes are not below the red marking and that the bristle length is
no less than 1 cm.
• the pad for wear before using.
Working with worn out, damaged and or wrong tools, could result
in possible damage to floors or their protective layers.
• Position the tool below the brush unit.
• Switch on the keyswitch.
The indicators light up briefly.
Brush unit button
• Press the brush unit button.
While being lowered, the unit begins to turn
slowly. This centres and locks the tool into
place.
The indicators light up.
Pedal brush unit
• Unlatch the foot lever and slowly lower the tool.
While being lowered, the unit begins to turn
slowly. This centres and locks the tool into
place.
The indicators light up.
Moving the machine forwards and backwards slightly as the brush
unit lowers, makes coupling easier.
25