Overview - La Cornue AlberTine 90 User Manual

2. Overview

Cooktop Burners
Before using the cooktop make sure all burners are in place
and all the grates on the range are properly placed.
The drawing by each knob indicates which burner that knob
controls (Fig.2-1).
Each burner has a special safety device that stops the flow of
gas if the flame goes out. Push in and turn a knob to the 'solid
flame symbol' lighting position (Fig.2-2).
Keep holding the knob pressed in to let the gas through to
the burner for a few seconds (about 4) (Fig.2-3). The igniter
should spark and light the gas. When a cooktop burner knob
is pressed in, sparks will be made at every burner – this is
normal. Do not attempt to disassemble or clean around any
burner while another burner is on. An electric shock could
result.
If, when you let go of the control knob, the burner goes out,
the safety device has not held in. Turn the control to the
OFF position and wait one minute, then try again this time
holding in the control knob for slightly longer.
Adjust the flame height to suit by turning the knob. On this
range the low position is beyond high, not between high and
off. The 'open flame symbol' marks the low position. Turn
ArtNo.280-0003 110 Hotplate USA
3
ArtNo.280-0100 Knob Full On EU
ArtNo.280-0101 - Knob Press In EU
Fig.2-1
Fig.2-2
Fig.2-3