Adjusting Upper Shaft Shield Plate Position - ELNA CE10 Service Manual

Adjusting Upper Shaft Shield Plate Position

The standard height of needle stop position should be 14.2 mm above the needle plate
surface when the machine is topped.
(A)
(B)
5
3
1
2
4
1 Remove the front cover unit. (See page 6)
2 (A) If the needle is higher than 14.2 mm, loosen
1
Screw and turn the Upper shaft shield plate
in the direction of (A).
(B) If the needle stops lower than the 14.2 mm
loosen Screw
shield plate
3 Place the right hand of the Upper shaft shield plate
2
at the center position of the Upper shaft sensor
and tighten Setcrew
4 Turn the handwheel toward you to check the needle
position again, then attach the front cover.
1
Screw
2
Upper shaft shield plate
3 14.2 mm
Upper shaft sensor
4
Needle #11
5
13
1
and turn the Upper shaft
in the direction of (B).
2
1 .
2
3
,
4