Adjusting X And Y Sensors (Instant Adjustment) - ELNA CE10 Service Manual

Adjusting X and Y Sensors (Instant Adjustment)

To adjust X and Y sensor (without removing the base unit):
1
2
8
9
3
5
4
6
7
6
10
1 Remove the base cover.
2 Remove the presser foot holder and attach the
Embroidery foop (A)
3 Turn the Power "ON" and select the Embroidery
Mode, then press pattern No.1.
4 Turn the handwheel by hand to check that the
Needle drops into the Starting position
4
the Template
2
5 Turn the Power "OFF".
6 If the needle position shifts in Y direction, loosen Screw
(A) and move the Y sensor fixing plate
9
adjust the needle drop position.
7 If the needle position shifts in X direction, loosen Screw
6
"B" through the sheet cover fixing plate hole and
adjust the X shield plate possition
8 Turn the Power "ON" and select pattern No.1 on the
Embroidery Mode, then check the Start position
9 Return the carriage to the home position and turn the
Power "OFF".
10. Remove the Template
, then reattach the base cover.
1
1
Embroidery hoop (A)
2
Template
3
Marks
4
Needle
5
Start position
6
Screw (B)
7
X-shield plate
8
Sheet cover fixing hole
9
Screw (A)
10
Y-Sensor fixing plate
27
.
1
.
.
7
and the Embroidery hoop
2
on
5
10 to
.
5