Table of Contents
Advertisement
Quick Links
W10PTOS/A
W10PTOS/B
W15PTOS/F
W15PTOS/G
GENERATORS
INSTALLATION AND
OPERATORS MANUAL
COPY YOUR MODEL AND SERIAL NUMBER HERE
No other WINCO generator has the same serial number as
yours. If you should ever need to contact us on this unit, it will
help us to respond to your needs faster.
MODEL _____________________________________________
SERIAL NUMBER _____________________________________
PURCHASE DATE ____________________________________
DEALER NAME ______________________________________
DEALER PHONE # ____________________________________
www.wincogen.com
Advertisement
Table of Contents
Related Manuals for Winco W10PTOS/A
Summary of Contents for Winco W10PTOS/A
- Page 1 OPERATORS MANUAL COPY YOUR MODEL AND SERIAL NUMBER HERE No other WINCO generator has the same serial number as yours. If you should ever need to contact us on this unit, it will help us to respond to your needs faster.
-
Page 2: Table Of Contents
THREE-POINT HITCH KIT “Troubleshooting Tables” near the end of this manual. ELECTRICAL CONNECTIONS The warranty listed in the manual describes what you can GROUNDING expect from WINCO should you need service assistance in PRE-START CHECKS the future. STARTING & STOPPING STARTING STOPPING STORAGE &... -
Page 3: Safety Information
SAFETY INFORMATION IMPORTANT SAFETY INSTRUCTIONS CAUTION This engine generator set has been designed and Keep the generator and surrounding area clean. manufactured to allow safe, reliable performance. Poor maintenance, improper or careless use can result in A. Remove all grease, ice, snow or materials that create potentially deadly hazards;... -
Page 4: Specifications
SPECIFICATIONS W10PTOS Watts 10,000 Amps 41.6 Input Speed 515 RPM Generator Speed 3600 RPM Input Shaft 1 3/8” - 6 spline Required Tractor PTO 20HP Gear Lube Volume 16 oz Type 85/90W-140 W15PTOS Watts 15,000 Amps 62.5 Input Speed 515 RPM Generator Speed 3600 RPM Input Shaft... -
Page 5: Introduction
If any damage is noted, it is always easiest to of typical units, and is subject to, and limited by, the refuse the shipment and let WINCO take care of the freight temperature and altitude. claim. If you sign for the unit, the transfer of the ownership... -
Page 6: Installation
C. The foundation surface should be flat. portable power source. When selecting or building a trailer WINCO THREE POINT HITCH to mount the generator, consider the following points: C. For safety the generator must be bolted to the three D. -
Page 7: Electrical Connections
Your WINCO PTO generator ships with a bonded neutral. You can safely use this generator without external Before deciding which system to install, first determine... - Page 8 ELECTRICAL CONNECTIONS particular plug. 3. Disassemble cable clamp and top cover. 7. Assemble cable clamp over the outer jacket of the wire DANGER: P 4. Remove one blade at a time, insert the stripped end of and tighten the two clamp screws. Special Note: For ERSONAL INJURY the appropriate colored wire designated above, and small size round (less than 3/4”) and flat cables, the...
-
Page 9: Pre-Start Checks
3. With engine idling, engage the power take-off drive. in Figure 7. If knuckles are not synchronized, the bar will age to flicker. Drive shafts shipped new from Winco are al- chatter when rotating, which will cause the generator ways synchronized and tethered so they can not be taken 4. -
Page 10: Starting & Stopping
STARTING & STOPPING STOPPING STARTING 1. Set the manual transfer to mid or normal (up) position. 1. Place the alternator circuit breaker in “off” position. Do not remove plug before opening the breaker. 2. With the power take-off drive disengaged, start the engine which will drive the generator. -
Page 11: Storage & Maintenance
If the generator is mounted on an off-highway trailer, such A. Inspect for loose or broken wiring connections. Make as the Winco trailer, it should be stored in a garage, barn sure that wiring connections are not loose at the generator end, circuit breakers, and receptacles. - Page 12 TROUBLE SHOOTING TABLE SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION Low Output Voltage 1. Undersized/overloaded. 1.Check for overload on the tractor or undersized. 2. Defective governor. 2. Check tractor governor. Tight or defective throttle levers and joints. 3. Low power - worn engine. 3.
-
Page 13: Wiring Diagrams
WIRING DIAGRAMS W10PTOS/A W10PTOS/B W10PTO WIRING BACK VIEW DIAGRAM VOLTMETER GENERATOR BREAKER 20 AMP N - G BOND RCPT 60 AMP *50 Amp on the RCPT W10PTOS/B 240V BREAKER GROUND LUG W15PTO WIRING DIAGRAM W15PTOS/F VOLTMETER W15PTOS/G BACK VIEW GENERATOR... -
Page 14: Limited Warranty
Air cooled units purchased for stock have 1 year to be sold. The warranty to the original retail customer commences on the date of sale of the product to them. All liquid cooled units have 180 days from the Winco invoice to submit a start up date. If no startup form is submitted, then warranty period starts on the Winco invoice date unit was sold. - Page 15 Note 2: 3rd Year warranty coverage is parts only/no labor. Note 3: Round trip mileage is limited to 200 miles per trip and a total of 2 trips per repair unless authorized in writing by the WINCO Service Dept.
- Page 16 225 S. CORDOVA AVE • LE CENTER, MN 56057 Sales: 507-357-6821• sales@wincogen.com Service: 507-357-6831 • service@wincogen.com www.wincogen.com 60706-241/F...
Need help?
Do you have a question about the W10PTOS/A and is the answer not in the manual?
Questions and answers