Advertisement
1. Playback Level Check
Mode
Playback
Signal
Tape for audio check
Audio video/headphone terminal left
Measurement Point
and right (8 Ω load)
Audio level meter and frequency
Measuring Instrument
counter
32 kHz mode: 1 kHz, –25 ± 3 dBs
48 kHz mode: 1 kHz, –25 ± 3 dBs
44.1 kHz mode:
Specified Value
The 7.35 kHz signal level during
EMP ON is –6 ± 2 dB from the signal
level during EMP OFF.
Switch Settings
Headphone volume button (ME4800 switch block)........
9th position decreased from MAX (8th position increased from
MIN) (Check on the EVF or LCD) (Note 1)
Note 1: Setting volume with adjusting remote commander
1) Set data: 02 to page: 0, address: FF.
2) Set data: 05 to page: 2, address: 01.
3) Set data: 08 to page: 3, address: 49.
The headphone volume will be set by the above data
settings. After checking the playback level, return the
data settings to the original settings.
1) Set data: 02 to page: 0, address: FF.
2) Set data: 00 to page: 2, address: 01.
3) Set data: 00 to page: 0, address: FF.
Checking Method
1) Check that the playback signal level of the headphone output
(Note 2) is the specified value.
Note 2: Impose a 8 Ω resistance to the left video audio/
headphone terminal, and turn the power ON from OFF,
or with the 8 Ω load, set the headphone output mode by
inserting the headphone terminal.
Note 3: When the tape for audio check is played back on this
unit, the output waveform in the video/audio output
mode will distort. The waveform will also distort near
the MAX volume in the headphone output mode. Do
not suspect a fault.
2. External Microphone Input Gain/
Channel Balance Check
Mode
Signal
Measurement Point
Measuring Instrument
Specified Value
Connection:
Connect the following terminals of the 26PIN multi connector using
a resistor.
1) Connect a 22 kΩ resistor between Pin 8 (S STATUS) and Pin
!§ (GND).
(Turn OFF SW2 of the I/O board-1 tool.)
2) Connect a 470 kΩ resistor between Pin 6 (S STATUS2) and Pin
!§ (GND).
(Turn ON SW3 of the I/O board-1 tool.)
Checking Method
1) Input a 1kHz, –44 dBs signal to Pins !∞ (left) and !£ (right) of
the 26PIN multi connector.
2) Check that the levels and level difference of the left and right
channels of the video output (Note 1) satisfy the specified values.
Note 1:Impose a 47 kΩ resistance to the left video audio/
headphone terminal, and turn the power ON from OFF.
6-55
Camera mode recording
1 kHz, –44 dBs signal
Pin !∞ (left) and Pin !£ (right) of 26PIN
multi connector
Audio video/headphone terminal left
and right (47 kΩ load)
Audio level meter
Signal level: –9.7 ± 3.0 dBs
Signal level difference: Below 2.0 dB
Advertisement
