Advertisement
2-5. REMOVAL OF VC-183 BOARD
5 Two connectors
4 Connector
CN4700, 4P
!¡ Two screws
(M1.7 x 2.5)
!™ Two screws
(M1.7 x 2.5)
6 ME4800 control switch block
CN2301, 5P
Position the harness as
shown in the figure.
CN1001, 6P
CN1002, 11P
C
7 Connector
CN4701, 2P
!£ Remove the VC-183 board in the arrow C direction.
When assembling, pay attention to the
positioning of the harness. See Fig. 1.
Pin
CN4700
CN1002
Fig.1 Arranging the Harness of VC-183 Board
A
B
9 Remove the cabinet bottom assembly
in the arrow A direction.
Be careful not to damege the flexible
board of the DD-91 board.
8 Two screws (M1.7 x 2.5)
CN1001
CN2301
CN4701
2 - 3
2 Battery plate
1 Two screws (M1.7 x 2.5)
3 Board-to-board connector 60P
CN6200, VC-183 board
CN3700, DD-91 board
!º Remove the DV terminal cover
in the arrow B direction.
Two zoom lens attaching
positioning pins.
The harness does not ride onto the
positioning pin.
Advertisement
