MOTO GUZZI NEVADA Service Station Manual page 54

Maintenance
pos. Description
1 Rear brake calliper fixing screw
2 Drilled screw for brake pipe on cal-
liper
Level check
Brake fluid check
•
Rest the vehicle on its stand.
•
For the front brake, turn the handlebar fully to the right.
•
For the rear brake, keep the vehicle upright so that the fluid in the reservoir is at the same
level with the plug.
•
Make sure that the fluid level in the reservoir is above the "MIN" reference mark:
MIN = minimum level
MAX = maximum level
If the fluid does not reach at least the "MIN" reference mark:
•
Check brake pads and disc for wear.
•
If the pads and/or the disc do not need replacing, top-up the fluid.
Top-up
Front brake:
•
Unscrew the two screws (1) of the
brake fluid reservoir (2) using a Phillips
screwdriver.
•
Lift and remove the cover (3) and
screws (1) as well.
•
Remove the gasket (4).
Rear brake:
•
Unscrew and remove the cap (5).
•
Remove the gasket (6).
•
Top-up the reservoir with brake fluid to
the correct level, which is between the
two "MIN" and "MAX" reference marks.
RISK OF BRAKE FLUID SPILLS. DO NOT OPERATE THE
BRAKE LEVER WITH BRAKE FLUID RESERVOIR CAP
LOOSENED OR REMOVED.
CAUTION
MAIN - 54
NEVADA - NEVADA ANNIVERSARIO
R
EAR BRAKE SYSTEM
Type Quantity
M8x30 2
- 1
Torque
25 Nm (18.44 lb ft)
25 Nm (18.44 lb ft)
Notes
-
-