.
Continuity of White cable (stator)
•
Check continuity of White cable between stator and regulator connector.
Replace stator.
OK
4.
Regulator voltage output
•
Refit connector in voltage regulator.
•
Run engine at 1900/000 RPM.
•
Connect Tester (00 v AC) to connector of voltage regulator, as follows:
•
Terminal (+) of Tester
•
Terminal (-) of Tester
•
value read must be approximately 1 volts.
OK
Check wiring (Yellow and Red/Green cable) between
regulator, carburettor starter and light switch.
See "Wiring Diagram" (P. 8).
E L E C T R I C A L S T A R T I N G S Y S T E M
L I G H T S Y S T E M
OK
Repair interrupted White cable.
See "Wiring Diagram" (P. 8).
Yellow cable -PIN 1- (1).
Black cable -PIN 2- ().
NO
NO
Tester (AC 00 v)
NO
5
4
3
2
1
1
F. 13