Electrical Starting System; Starter Motor Does Not Work - Malaguti Centro 50 4T Workshop Manual

STARTER MOTOR DOES NOT WORK

Check:
1. Fuse, 10 A / 5 A
2. Battery
3. Starter motor
4. Starter relay
5. Key switch
6. Start switch
7. Front/rear "Stop" switch
8. Starting system wiring connections
1. Fuse, 10 A /  A
• See "Checking fuses" (P. 15).
OK
. Battery
• Remove battery and connect Tester (0 v DC), as follows:
• Terminal (+) of Tester
• Terminal (-) of Tester
• If voltage level is lower than 1.4 v, recharge using a suitable battery charger.
• After charging the battery, do not use it for approximately 30 minutes; now measure voltage level again.
• 1,8 v or more
• 1, v
• 1,0 v
OK
E L E C T R I C A L S T A R T I N G S Y S T E M
Replace fuse.
Eliminate short-circuit of wiring
Battery (+) pole.
Battery (-) pole.
Battery is charged.
Battery needs to be recharged.
Replace battery.
NO

F. 6