Ignition System; The Ignition System Does Not Work - Malaguti Centro 50 4T Workshop Manual

THE IGNITION SYSTEM DOES NOT WORK

Check:
1. Spark plug
2. Spark plug cap resistance
3. Pick-up resistance
4. Key switch
5. Wiring connections
1. Spark plug
• Check condition of spark plug.
• See "Engine Workshop Manual".
OK
. Spark plug cap
• Remove spark plug cap.
• NOTE: when removing spark plug cap, avoid pulling it.
• To remove
• To connect
• Before connecting the spark plug cap, check the HV cable and cut off a piece of approximately 5 mm.
• Connect Tester (KΩ) to spark plug cap as follows:
• Terminal (+) of Tester
• Terminal (-) of Tester
• Spark plug cap resistance: 5 KΩ at 20° C.
OK
I G N I T I O N S Y S T E M
Faulty spark plug: replace it.
turn anti-clockwise.
turn clockwise.
Spark plug side (1).
High voltage cable side (2).
Replace spark plug cap.
NO
NO
18
Tester (KΩ)
1

F. 1