Abbreviations - Malaguti Centro 50 4T Workshop Manual

ABBREvIATIONS

• F Figure
• Cs Tightening torque
• P Page
• Pr Paragraph
• S Section
• Sc Diagram
• T Table
• v Screw
the letter V in the illustrations refers to retaining or adjusting screws.
The number following this letter refers to the number of the same type
of screw in the unit or component described and illustrated. Letters not
followed by a number indicate a single screw. In case of different
screws being referred to in the illustration, the letter V is followed by a
number and a small letter, for instance: (V4a).
Unless otherwise specified, units and components are reassembled by
proceeding in the reverse order of removal.
Before any servicing, make sure that the vehicle is perfectly
stable.
The front wheel should preferably be anchored to the equipment
integral with the lifting board (A).
I N T R O D U C T I O N
A