To Remove the Door Assembly
1. Use a plastic putty knife or small flat blade screwdriver to
remove the top and bottom hinge covers.
Remove Top
and Bottom
Hinge Covers
2. Use a TORX T-20 screwdriver to remove the two (2)
bottom hinge screws (see Figure 2).
3. Use a TORX T-20 screwdriver to remove the two (2) top
hinge screws (see Figure 2).
Remove two
T-20 Torx
Screws
Removing the Door Assembly
Figure 1
Figure 2
4. Lift door slightly to remove locator-pin from keyhole slot
in front panel. Remove door assembly from dryer.
Locator Pin and Keyhole Slot
Whirlpool & Maytag 9.2 Cu. Ft. Steam Dryer
COMPONENT ACCESS
Figure 3
4-3
n