Whirlpool WED9500E SERIES Service Manual page 21

Troubleshooting Guide
Continued from page 2-10
Problem Possible Cause
Heats in Air Cycle Heater coil shorted.
Heater relay shorted.
Heater system problem.
Shuts Off Before Dryness or Dry Level setting for
Clothes Are Dry auto cycles.
Lint screens full.
Heater vent clogged.
Moisture Sensor problem.
Adjust Customer Focused Dryness
Level.
Water Valve Not Steam cycle not selected.
Dispensing (on some
No water to valve.
models)
(Water valve
No water from valve.
is activated
intermittently during
the steam cycle.)
Water Leaking From Residue buildup on water nozzle
Dryer (on some opening.
models)
(Too much water
being dispensed
during steam cycles.)
For Service Technician Use Only
DIAGNOSTICS & TROUBLESHOOTING
Checks & Tests
See Test #4: Heat System, page 3-12.
See Test #4: Heat System, page 3-12.
See Test #4: Heat System, page 3-12.
Increase Dryness or Dry Level setting for one or more auto
cycles.
Clean if necessary. Refer customer to "Use and Care Guide".
Clean if necessary. Refer customer to "Use and Care Guide".
See Test #5: Moisture Sensor, page 3-17.
See Test #5a: Adjusting Customer-Focused Dryness Level, page
3-18.
Refer customer to "Use and Care Guide".
Verify water supply is turned on.
See Test #9: Water Valve, page 3-22.
Unscrew nozzle and clean if necessary.
Whirlpool & Maytag 9.2 Cu. Ft. Steam Dryer 2-11
n