Component Locations - Whirlpool WED9500E SERIES Service Manual

COMPONENT ACCESS

COMPONENT LOCATIONS

COMPONENT LOCATIONS - WHIRLPOOL (FIGURE 1)
Drum Light
Assembly
Door Switch
(Location may vary
between models)
• Motor Assembly
• Thermal Fuse
• Outlet Thermistor
• Moisture Sensor Strips
COMPONENT LOCATIONS
Figure 16 - Component locations.
COMPONENT LOCATIONS - MAYTAG (FIGURE 2)
Drum Light
Assembly
Door Switch
(Location may vary
between models)
Light Blue
• Motor Assembly
• Thermal Fuse
• Outlet Thermistor
• Moisture Sensor Strips
(rear sensor strips not on all models)
Figure 16 - Component locations.
4-2 Whirlpool & Maytag 9.2 Cu. Ft. Steam Dryer
n
FOR SERVICE TECHNICIAN'S USE ONLY
Component Locations
FOR SERVICE TECHNICIAN'S USE ONLY
Function
Start
Run
Centrifugal Switch (Motor)
Black
White
White
Light Blue
Gas Valve, Gas Dryer
Function
NOTE: Refer to Figure 10b, page 17,
for gas dryer component locations.
Contacts
1M 2M 3M 5M 6M
=
Contacts closed
Lt. Blue
Red
Pluggable Drive Motor Switch
DO NOT REMOVE OR DESTROY
NOTE: Refer to Figure 10b, page 18,
for gas dryer component locations.
Contacts
1M 2M 3M 5M 6M
• ACU
• User Interface (UI)
• Inlet Thermistor (Gas)
• Water Nozzle
• Water Valve
• Thermal Cut-off
• Inlet Thermistor (Electric)
• High Limit Thermostat
• Heater Assembly
NOTE: Refer to Figure 2, page 3-13,
for gas dryer component locations.
• ACU (beneath console)
• User Interface (UI)
• Inlet Thermistor (Gas)
• Water Nozzle
• Water Valve
• Thermal Cut-off
• Inlet Thermistor (Electric)
White
• High Limit Thermostat
Green-Yellow
• Heater Assembly
Red-White