Removing The Gas Burner Assembly Coils (Gas) - Whirlpool WED9500E SERIES Service Manual

9.2 cu. ft. steam dryer
Table of Contents

Advertisement

Removing the Gas Burner Assembly Coils (Gas Models Only)
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
To Remove the Ignitor, Flame Sensor, High-Limit
Thermostat and Thermal Cutoff (Gas Models Only)
1. Unplug dryer or disconnect power.
2. Turn off gas supply to dryer.
3. Perform the procedures on page 4-4, "Removing the
Top Panel" and "Removing the Console/UI" prior to
performing the following steps.
4. Perform the procedures on page 4-6, "Removing the Front
Panel" prior to performing the following steps.
5. Remove the ignitor from the burner (see page 4-13 for the
procedure).
6. Disconnect the 2-wire and 3-wire connectors from the
burner coil assembly terminals (see Figure 3).
7. Remove the two screws from the burner support bracket
and remove the bracket from the burner (see Figure 3).
8. Remove the two screws from the front of the burner
bracket and remove the burner assembly from the dryer.
Gas Burner Assembly
Figure 1
Gas Burner Assembly
Figure 2
Coils w/Connectors
Support Bracket
Screws
9. Remove the two screws from the coil retaining bracket.
Retaining Bracket Screws
10. Lift the two coils off their cores and remove them.
Whirlpool & Maytag 9.2 Cu. Ft. Steam Dryer
COMPONENT ACCESS
2-Wire
Burner Bracket
Screws
Figure 3
Figure 4
Figure 5
3-Wire
4-15
n

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Medb955f seriesMgdb955f seriesWgd9500e series

Table of Contents