Icare HOME Instruction Manual page 16

Icare HOME tonometer Instruction manual for health care professionals
Icare HOME tonometer Instruction manual for health care professionals
Correct measurement position.
Correct alignment of the
tonometer.
5. Press the measurement button:
6. If both eyes are measured repeat steps 1-5 using your other eye.
7. If an error occurs, press the Measure button briefly (1 second) and continue the
measurement. See also section 9 Trouble shooting.
8. Press the power button for three seconds to turn the tonometer off. The probe slides
out of the probe base.
9. Remove and discard the used probe properly.
Incorrect measurement position.
Incorrect alignment of the
tonometer.
Single mode:
Press the button briefly (1 second) and you hear a
short beep, repeat it to take one measurement at
a time till you hear a long beep and see the Done
light (17) illuminated on the back panel.
Series mode:
Keep the measurement button down to obtain
the sequence of six measurements till you hear a
long beep and see the Done light illuminated on
the back panel. The button must be pressed for
at least 3 seconds.
ENGLISH www.icare-usa.com
Incorrect measurement position.
Incorrect alignment of the
tonometer. Readjust so that you see
only the front of the tonometer and
the green light symmetrically in the
center of your view.
16
English