Maintenance - Bodyworx J1600EA Owner's Manual

MAINTENANCE

CLEANING
Remove dust on the treadmill with vacuum or slightly damp cloth. Fold up the deck and clean the floor with
vacuum periodically will help to prolong the treadmill product life.
Never use solvents on the deck or running belt. Use of solvents can reduce critical lubrication of the deck and
belt.
LUBRICATING THE DECK
A well-lubricated deck will ensure high performance of your treadmill and reduce the level of normal war and
tear to important components. This treadmill has been pre-lubed at the factory. However, for optimal
performance, the running deck may require periodic lubrication. With average usage ( 30 minute workout
session at 5-6km/h 3 times a week for two people) lubricate every four to six months. Your may adjust the
timing of the lubrication based on the intensity of the treadmill use level.
To check the lubrication level, simply lift the running belt, and put your hand as far into the center of the belt as
you can reach. If your hand shows signs of silicone, then it does not need additional lubrication. If the board
feels dray and there is very little evidence of silicone on your hand, then additional lubrication should be added.
TO LUBRICATE THE DECK:
Stop running belt so that the seam is located on top and in the center of the deck.
Insert nozzle into spray head of lubricant can.
Lift running belt.
Position nozzle between the belt and the board approximately 200mm (8" ) from the front of the treadmill.
Apply the silicon from the front to the rear of the treadmill on each side of the treadmill. Try to reach the spray
as far into the center of the running deck as possible. The spray time should be approximately four seconds
for each side.
6. Spread the silicon by running the treadmill at 1 Km/H and step gently on the belt from left to right. Do that
for a few minutes and allow the silicon to soak into the belt.
12
Owner's Manual