Audio Server; Sound Clip Upload 1 To 3 - Canon VB-S800VE Operation Manual

[Input Volume]
Set the input volume from the built-in microphone when [Audio Input] is set to [Enable].
This is applied when [Audio Server] > [Audio Transmission from the Camera] (P. 133) is set to [Enable].
[Current Volume Level]
When [Audio Input] is set to [Enable], the current volume level is displayed on the status bar.
[Low-Cut Filter]
If [Audio Input] is set to [Enable], select whether to use the function to cut out low-frequency audio input. If you select
[Enable], low frequency sound, such as wind noise generated when wind reaches the microphone, is reduced, which
makes it easier to hear people talking.
If you select [Disable], the audio of ambient sounds such as traffic and crowds is input with greater fidelity.
S30VE
[Mute During Pan/Tilt]
Specify this setting when [Audio Input] is set to [Enable]. If you select [Mute], audio input is muted during pan/tilt
operations.
[Output Volume]
Set the output volume from the Viewer to the speaker connected to the camera.
This is applied when [Audio Server] > [Audio Reception from Viewer] (P. 133) is set to [Enable].
[Audio Communication Method]
Select the audio transmission/reception method.
[Half Duplex]
You can prevent howling that occurs when the microphone and speaker are placed nearby. However, there is no sound
sent from the camera to the viewer while the camera is receiving audio from the viewer or while an audio file is being
played back.
[Full Duplex]
Audio can be transmitted from the camera to the viewer even while the camera is receiving audio from the viewer.

Audio Server

Settings for audio transmission from the built-in microphone, and audio reception from the Viewer to the camera.
[Audio Transmission from the Camera]
Select [Enable] to transmit audio from the microphone built in the camera to the Viewer.
[Enable] cannot be selected if [Video and Audio] > [Audio] > [General Sound] > [Audio Input] is set to [Disable].
[Voice Activity Detection]
Select whether to detect when there is no sound coming from the microphone.
When set to [Enable], audio data transmission will pause while there is no sound input from the camera. This can reduce the
load on the network used.
[Audio Reception from Viewer]
Select to receive audio from Camera Viewer and RM Viewer.
Received audio can be output from a speaker with an amplifier connected to the camera.

Sound Clip Upload 1 to 3

You can upload up to three sound clips for playback when an event is triggered.
Network
Network
Audio
4
133