Table of Contents
Advertisement
Important
The intended effect may not be achievable, depending on the size and movement speed of the subject.
S30VE
[Pan/Tilt Speed Control]
Select the pan/tilt control mode.
If [Control by zoom position] is selected, the pan/tilt speed will be slower in telephoto, and faster in wide-angle.
4
Day/Night (When Auto Is Set)
Set conditions for switching Day Mode and Night Mode when [Day/Night] is set to [Auto].
[Switching Brightness]
Select the brightness for switching Day/Night Mode when [Day/Night] is set to [Auto].
Select [Darker] if you want to capture video in color as much as possible.
Select [Brighter] to reduce noise. Note that this mode switches to monochrome sooner.
[Response (sec.)]
Select the number of seconds for determining when to switch Day/Night Mode, when [Day/Night] is set to [Auto]. Day/Night
Mode switches when the brightness continues to exceed or fall below the brightness set in [Switching Brightness] for the
number of seconds selected.
Select [30] or [60] if brightness changes frequently, such as when a light source passes in front of the camera. Select [5] or
[10] if change in brightness is minimal.
Installation Conditions
Configure settings for camera use suitable for the location the camera will be installed.
[LED Setting]
Select whether to turn on the LED indicating the camera operation status.
If you select [Turn On], the LED will light up when turning on the power, when rebooting, and during normal use.
If you select [Turn Off], the LED will light up for several seconds during startup, and then turn off.
Regardless of the setting, the LED will flash when initializing settings.
[Image Flip]
Select whether to vertically flip the video.
Select the setting suited to the camera installation method, such as ceiling mounting or placing on a desk.
Camera Position Control
Settings for camera use when there are no camera control restrictions for users or requests for camera control privileges.
S30VE S910F
[Restricted to Presets]
Restricts camera control of the camera angle, such as with Camera Viewer, to presets, including the home position, for
users other than administrators.
[Camera Position without Control]
Select the camera operation when there are no users with camera control privileges.
If [Return to Home Position] has been selected, the home position of the camera must be set in advance with [Camera] >
[Preset] > [Preset Registration] (P. 118).
External Input Device
Enter each device name in order to identify the corresponding external input device being connected.
[Device Name]
Enter the name of the device connected to the external input device terminal.
101
Advertisement
Table of Contents
Troubleshooting
