[Video And Audio] > [Audio] Setting Audio Input/Output; General Sound - Canon VB-S800VE Operation Manual

[Video and Audio] > [Audio]
Setting Audio Input/Output
Settings for audio input from the built-in microphone and audio output from the Viewer. The output sound clip used when an
event is triggered can also be registered.
[Audio Server] is the same as [Server] > [Audio Server]. Settings configured on one [Audio Server] page are also reflected
on the other.
Important
• Video and audio can be distributed to up to 30 clients. However, when there are many clients or they are connected to the camera over
an SSL/TLS connection, the video frame rate may slow down and the sound may drop out if audio reception from the camera is
enabled.
• The video and audio may not be synchronized.
• If the [Input Volume] setting is changed after setting volume detection (P. 150), check the detection setting again.
• If the [Low-Cut Filter] setting is changed after setting volume detection (P. 150), check the detection setting again.
• The audio may be temporarily interrupted, depending on the performance of the computer and the network environment.
• The audio may be interrupted if anti-virus software is enabled.
• Communication may be temporarily interrupted, cutting off the audio, if the LAN cable is unplugged and plugged in again. If this
occurs, reconnect from the Viewer.
• Use a speaker with an amplifier to connect to the camera (please refer to "Installation Guide").

General Sound

Set the audio input/output volume and the operation of audio input from the built-in microphone.
[Audio Input]
Select whether to use audio input from the built-in microphone. If you select [Enable], you can use functions related to audio
input such as [Audio Server] > [Audio Transmission from the Camera] (P. 133) or [Event] > [Audio Detection] > [Volume
Detection Event] (P. 150).
If you select [Disable] and click [Apply], the following settings are locked and audio input functions are disabled.
– [Video and Audio] > [Audio] > [Audio Server] > [Audio Transmission from the Camera] > [Disable]
– [Server] > [RTP Server] > [RTP Streaming 1] – [RTP Streaming 5] > [Audio Transmission] > [Disable]
– [Event] > [Audio Detection] > [Volume Detection] > [Volume Detection Event] > [Disable]
132
The following settings can be configured here.
• General Sound
• Audio Server
• Sound Clip Upload 1 to 3