Day/Night (When Auto Is Set) - Canon VB-730F Mk II Operation Manual

[Maximum Digital Zoom Magnification]
Sets the maximum zoom magnification for digital zoom.
HM4x
[Image Stabilizer]
Select this to enable or disable blur reduction in video due to camera vibration.
If there is still blur after selecting [On1], select [On2].
The angle of view will be narrower and video noisier when using the Image Stabilizer, compared to when it is not used.
HM4x
Important
• The image stabilizer is not effective when the subject is shaking.
• Stabilization is not effective beyond a certain degree of vibration or for momentary vibrations.
• If you select [On2], it is recommended to select a video reception size less than [640 x 480].
• If you use stabilization, please refer to the information listed in the following "Important" sections.
– The "Important" section in "Setting Privacy Mask" (P. 133)
– The "Important" section in "Setting View Restriction" (P. 115).
– The "Important" section in "Viewing Video with the Camera Viewer" (P. 50).
– The "Important" section in "Registering Presets" (P. 118).
[Smart Shade Control Strength (Auto)]
Select the control strength when [Smart Shade Control] (P. 104) is set to [Auto].
• [Mild]: Select if noise is noticeable.
• [Medium]: Recommended setting for Auto mode (default setting)
• [Strong]: Select to increase visibility in dark areas.
[Haze Compensation Strength (Auto)]
Select the strength of compensation when [Haze Compensation] (P. 105) is set to [Auto].
Note
When [Haze Compensation] is set to [Auto] and [Haze Compensation Strength (Auto)] is set to [Strong], contrast may be strong if the
subject is not obscured by haze. If this happens, set [Haze Compensation Strength (Auto)] to [Mild].
[Motion-Adaptive Noise Reduction]
When [Enable] is selected, noise reduction is automatically adjusted according to movement. For scenes in which there is
little movement, noise reduction is increased and data size decreases.
Important
The intended effect may not be achievable, depending on the following conditions:
– the size of the subject
– the movement speed of the subject
– the scene with a lot of noise
– subjects without bright/dark contrast (white walls, etc.)
HM4x S30
[Pan/Tilt Speed Control]
Select the pan/tilt control mode.
If [Control by zoom position] is selected, the pan/tilt speed will be slower in telephoto, and faster in wide-angle.

Day/Night (When Auto Is Set)

Set conditions for switching Day Mode and Night Mode when [Day/Night] is set to [Auto].
[Switching Brightness]
Select the brightness for switching Day/Night Mode when [Day/Night] is set to [Auto].
Select [Darker] if you want to capture video in color as much as possible.
Select [Brighter] to reduce noise. Note that this mode switches to monochrome sooner.
[Response (sec.)]
Select the number of seconds for determining when to switch Day/Night Mode, when [Day/Night] is set to [Auto]. Day/Night
Mode switches when the brightness continues to exceed or fall below the brightness set in [Switching Brightness] for the
number of seconds selected.
Select [30] or [60] if brightness changes frequently, such as when a light source passes in front of the camera. Select [5] or
[10] if change in brightness is minimal.
HM4x
S31
5
97