Bosch GCM 12 GDL Professional Original Instructions Manual page 25

OBJ_BUCH-1464-001.book Page 25 Monday, May 9, 2011 3:47 PM
– Swivel the depth stop 30 outward.
– Press locking lever 5 and tilt the glide arm to the desired
position.
– Turn adjusting screw 29, until the screw end touches
depth stop 30.
– Slowly guide the glide arm upward.
Sawing Profile Strips/Mouldings (Floor and Ceiling Strips)
Profile strips/mouldings can be sawn in two different ways:
– Placed against the fence
– Lying flat on the saw table.
In addition, the cut can be perfomed with or without slide
movement depending on the width of the profile strip/mould-
ing.
Floor Strips/Mouldings
The following table contains instructions for sawing floor strips/mouldings.
Settings
Floor strip/moulding
Inner corner Horizontal mitre angle
Bevel angle
Positioning of work-
piece
The finished work-
piece is located...
Outer corner Horizontal mitre angle
Bevel angle
Positioning of work-
piece
The finished work-
piece is located...
Bosch Power Tools
Special Workpieces
When sawing curved or round workpieces, these must be es-
pecially secured against slipping. At the cutting line, no gap
may exist between workpiece, fence and saw table.
Provide for special fixtures, if required.
Always make trial cuts with the mitre angle setting first on
scrap wood.
Placed
against the
fence
Left side Right side
45° left 45° right
0° 0°
Bottom edge on saw Bottom edge on saw
table table
... to the left of the ... to the right of the
cut cut
45° right 45° left
0° 0°
Bottom edge on saw Bottom edge on saw
table table
... to the right of the ... to the left of the
cut cut
English | 25
Lying flat on
the saw table
Left side Right side
0° 0°
45° left 45° right
Upper edge against Upper edge against
the fence the fence
... to the left of the ... to the right of the
cut cut
0° 0°
45° right 45° left
Upper edge against Upper edge against
the fence the fence
... to the left of the ... to the right of the
cut cut
1 609 929 Y62 | (9.5.11)