Changing the Character String That Is Output for Read Errors
You can change the character string that is output for read errors.
[Inspect]
−
[Inspection]
[Error string]
Setup Item
Error string
Max. 20 digits
(Default value: NG)
Changing the Items That Are Displayed on the Test Measurement and Run Display
Press [Test] − [Continuous test] − and then use
Display setting
Num. of char.
Characters
Unstable Reading Results
Reading Is Unstable Due to Low Contrast
Adjust the brightness to improve the contrast of the bar code.
Adjusting the Brightness: p. 77
FQ2-S/CH User's Manual
−
[Add item.]
−
[Bar code]
Setting Value
Sets the text string to be output when a read error occurs.
Displays the number of characters that were read.
Displays the character string that was read.
−
[Details] Tab Page
Description
ASCII code table: p. 185
− [Display setting] on the Test Display.
Description
−
[Output parameter]
−
Reading Barcodes
187