Errors - Omron FQ2-S/CH Series User Manual

Expression Data name
text string
SX Reference X
SY Reference Y
ST Reference angle
RX Detection coordinate X −99,999.9999 to 99,999.9999
RY Detection coordinate Y −99,999.9999 to 99,999.9999
C Count
4-18 Calculations and Judgments Using Inspection Item Data: p. 323
Measurement Data That Can Be Logged
The following values can be logged as measurement data.
Parameter
0: Judgement is OK
−1: Judgement is NG
Judgement −13: Teaching not performed error
−14: Figure not registered error
−15: Out of range error
Correlation 0 to 100
Position X -99999.9999 to 99999.9999
Position Y -99999.9999 to 99999.9999
−180 to 180
Angle
Count 0 to 32
*When logging data is output, the data is output in the order of the above table.
If more than one item is stored, results are output for each model.
7-6 Logging Measurement Data and Image Data: p. 392

Errors

Errors in Teaching
A teaching error message will appear if the contrast of the image within the model registration region is too low.
Select a region with a larger contrast between light and dark areas compared to the region that was registered
as the model and re-register it as the model.
FQ2-S/CH User's Manual
Description
−99,999.9999 to 99,999.9999
−99,999.9999 to 99,999.9999
−180 to 180
0 to 32
Range of value
This is the X coordinate of the position
where the model was registered.
This is the Y coordinate of the position
where the model was registered.
This is the angle when the model was
registered.
−99,999.9999 to 99,999.9999
This is the X coordinate of the detection
point when the model was registered.
This is the Y coordinate of the detection
point when the model was registered.
This is the number of models found.
Description
This is the measurement judgment results.
This is the measured correlation.
This is the measurement position X.
This is the measurement position Y.
This is the measurement angle.
This is the number of models found.
Inspecting with the Search Inspection Item
Data range
229