Diskette Drive Removal; Removing The Diskette Drive - NEC POWERMATE 2000 Service And Reference Manual

Diskette Drive Removal

Remove the diskette drive as follows.
1. Remove the system unit bottom cover (see "Bottom Cover Removal").
2. Remove the four screws (see the following figure) securing the diskette
drive to the support plate. Hold the drive in place and perform step 3.
3. Tilt out the top of the diskette drive just enough to carefully unplug the
diskette drive interface cable from its connector on the drive.
!
Release the cable retainer on the drive connector by gently pushing the
ends of the retainer away from the connector.
!
Carefully pull the cable out of the drive connector.
4. Remove the diskette drive from the system unit.
A – Screws (4)
B – Diskette Drive
C – Interface Cable Connector
3-10 Disassembly and Reassembly

Removing the Diskette Drive

D – Interface Cable
E – Support Plate