Table of Contents
Advertisement
4.3" Designer Touch Screen
20 • 4.3" Designer Touch Screen: TPMC-4SMD-FD
Touch Test Screen
During touch screen calibration, a crosshair appears at the center of the screen.
Touch the center of the crosshair, which then moves to the upper left part of the
screen. Touch the center of the crosshair again, and it moves to another part of the
screen. Continue touching the center of the crosshair until calibration is complete.
NOTE: When touching the screen during calibration, be as accurate as possible. For
best results, use the tip of a capped pen or the eraser end of a pencil.
Sensor Test
From the Diagnostics menu, touch Sensor Test to display the Diagnostics – Sensor
Tests screen. If contact sensors are connected to the TPMC-4SMD-FD, the
respective indicator changes from Inactive to Active as appropriate for each sensor's
activity. Similarly, the TPMC-4SMD-FD's own proximity sensor's indicator
changes from Inactive to Active when the TPMC-4SMD-FD senses motion in front
of the unit. Use the Sensor Strength controls to adjust proximity sensor sensitivity.
Touch Back to return to the Diagnostics menu.
"Diagnostics – Sensor Tests" Screen
Crestron TPMC-4SMD-FD
Installation & Operations Guide – DOC. 7174F
Advertisement
Table of Contents
