Equalizer; Cameras - Bosch dicentis Configuration Manual

20 en | Web browser interface
–
–
5.4.4

Equalizer

Click the Equalizer button to open the Equalizer settings page:
The Equalizer settings page is used to set the equalizer settings of the audio line input and
output of the Wireless Access Point and Wireless Devices loudspeaker.
Equalizer filters
–
–
–
Equalizer settings
Proceed as follows to configure a filter:
1.
2.
3.
4.
5.4.5

Cameras

Click the Cameras button to open the Camera settings page:
–
–
–
2016.07 | V2.0 |
– Maximum: Sets the DAFS function to on and selects the maximum algorithm for
speech, which reduces the risk of acoustic feedback (howling) at higher system
volume levels.
Note: Audio artifacts might occur at higher volume levels.
Feedback prevention:
– Loudspeaker active when microphone is on: The participant's loudspeaker is active
when their microphone is on.
– Attenuate headphone when speaking: Attenuates the headphone volume of the
Wireless Devices with 18 dB when selected and the microphone is on.
Test tone: Click the appropriate button to test the audio in the system with a 1 KHz or
Sweep tone. Click the Off button to stop the test tone.
– When Send test tone to loudspeakers is selected, generates the selected test tone
to the connected Wireless Devices loudspeaker.
– When Send test tone to headphones is selected, generates the selected test tone to
the connected Wireless Devices headphone.
– When Send test tone to line output is selected, generates the selected test tone to
the audio line output of the Wireless Access Point.
Filter 1 type: Shelving filter - A shelving filter for low frequencies with a fixed quality
factor.
Filter 2, 3, 4 type: Full parametric section - Three full parametric filters with adjustable
quality factors, gains and frequencies.
Filter 4 type: Shelving filter - A shelving filter for high frequencies with a fixed quality
factor.
Enter the frequency of the filter. Possible values from 50 Hz up to 22 kHz.
Enter the gain of the filter. Possible values from -12 dB to +12 dB with steps of 0.1.
Enter the quality (Q) factor of the filter. Possible values from 0.4 to 14 with steps of 0.1.
Enable or bypass the filter by clicking the checkmark. All changes are immediately
applied.
Overview camera: Defines the camera used as the overview camera.
Pre-position: Defines the preposition of the camera used for the overview.
Note: Only available when a PTZ/Dome camera has been selected as an overview camera
(if a fixed camera or None is selected, this field is not visible). A total of 6 cameras can be
connected. The following HD‑SDI switchers are supported:
– TVOne CORIOmatrix mini.
– Kramer MV-6.
SDI Switcher: Enter the IP address of the HD‑SDI video switcher used. Do not use leading
zeros. If leading zeros are entered, the DCNM‑WAP will not be able to control the
switcher.
Configuration manual
DICENTIS
Bosch Security Systems B.V.