Seats - Bosch dicentis Configuration Manual

24 en | Web browser interface
9.
10. In the right-hand browser window, select Subscribe.
11. For the Primary WAP (left-hand browser window) , make sure the following messages are
12. For the Secondary WAP (right-hand browser window), make sure the following messages
13. Make sure a yellow triangle is not displayed in the bar at the bottom of the page. This
14. The redundant WAP is now ready for use.
Notice!
After booting the redundant system, check if the system is running in redundant mode. To do
this, check the LEDs on the WAP, and/or check the status of the WAP in the browser.
–
Notice!
When the system is reset to the factory defaults, the latest version of the software that the
system was upgraded to, and the installed licenses, will be maintained.
5.4.8

Seats

Click the Seats button to open the Seat settings page.
Here the Wireless Devices can be assigned to seats:
2016.07 | V2.0 |
– Only a limited number of options are displayed, because this WAP is being set as the
secondary WAP. All options will be available in the secondary WAP if the primary
WAP is switched off or fails.
– The Secondary button is shaded dark gray to indicate that the WAP is set as the
secondary WAP.
– The Standalone and Primary buttons are grayed out.
In the left-hand browser window, select the Subscription mode check box, so that a WAP
can be subscribed to the primary WAP.
– The secondary WAP searches for and subscribes to the primary WAP. This can take
some time depending on the network.
displayed below the Subscribe button
– Configured: Primary and Secondary.
– Operational: Primary and Secondary connected.
are displayed below the Subscribe button:
– Configured: Secondary and Primary.
– Operational: Secondary and Primary connected.
triangle indicates that the connection to the WAP is either incorrect or has been lost. If
this triangle is displayed, refer to the messages below the Subscribe button for each WAP
to determine the status of the system.
General settings:
– DCNM-WDE GUI language: Select the GUI language for the Wireless Device
Extended (DCNM‑WDE) touch screen.
– Factory default button: Click this button to reset the Wireless Access Point to the
factory default. After a factory default, all settings are returned to their default value,
and all Wireless Devices need to be subscribed.
Important: Before you activate the factory default, make sure all Wireless Devices
are switched on and in range of the DCNM‑WAP. If Wireless Devices are not de-
initialized during a factory default, they must be de-initialized manually before they
can be subscribed again.
Configuration manual
DICENTIS
Bosch Security Systems B.V.