Tele System ts3002 User Manual page 45

Backup by USB: It is possible to backup the user's channel database for future re-use in case the
2.
decoder is reset, which is also recommended before performing a Software update.
3.2.6 Set Default (Factory Reset)
The Set Default function resets the receiver to its factory settings.
CAUTION!
Factory reset means you will lose all personalised settings and all the channels previously stored.
3.3 Multimedia Menu
The USB port on the front of this receiver allows for multimedia files to be read and for unencrypted digital
satellite programs to be recorded.
CAUTION!
x
The receiver is compatible with USB memory devices formatted with FAT32 file systems.
x
When connecting a hard disk, free memory space of at least 300 GB is required.
x
To work properly, some hard disks that are auto-powered via USB could require an external power supply.
x
Full compatibility with all USB memory devices on the market is not guaranteed.
x
The use of a device with at least 4 GB of free (unused) memory is advised.
USB memory device connection
After the USB is connected, and after each decoder start-up, a control of the device is undertaken that could
last a few minutes depending on the amount of memory in the device.
After the first recording, a folder called MYRECORD is created, that acts as the receiver's working folder for
recordings.
CAUTION!
Never disconnect the USB memory device during multimedia reproduction, while recording, during Timeshift, formatting
or in the presence of a recording event timer: the devices involved may be irreversibly damaged!
3.3.1 My Album
Select the Multimedia - My Album menu, press BLU for browning the folders of the memory device, then
press OK on the target file to view the photo.
3.3.2 My Music
Select the Multimedia - My Music menu, browse the folders of the memory device and press OK to listen to
the music files.
3.3.3 My Movie
Select the Multimedia - My Movie menu, browse the folders saved on the memory device and press OK to
view the video files.
3.3.4 My Recorder
3.3.4.1 Recorded List
Using / , select the recording you wish to reproduce and press OK to see a preview. Press OK again and
the recording appears full screen. It is also possible to delete content by pressing the RED button (Del
option) on the file selected.
Press INFO to access the memory device's organization menu.
3.3.4.2 Recording Device
Allows the memory device that is connected to the decoder to be totally or partially formatted according to its
partition capacity:
Format (RED button): only formats the partition selected in the Partition field
1.
Format Disk (GREEN button): formats the entire storage device connected to the receiver
2.
CAUTION!
x
If the message PVR initialisation incomplete appears, it is necessary to totally format the device connected to the
USB port.
x
Upon first use of the memory device, it is strongly advised that you format it from the Recording Device menu.
3.3.4.3 Recording Preference
Menu to modify the recording parameters (section 2.5.1) and Timeshift (section 2.5.2):
Timeshift Size: View the size of the memory dedicated to Timeshift recording. The memory size is
1.
automatically set based on the total size of the disk connected to the receiver
TS3002
15