Tele System ts3002 User Manual page 43

Satellite/s channels scan
To conduct a channel scan on selected satellites:
x
Press the BLUE Scan button to scan only the satellite selected. Otherwise, press the RED Scan All
button to extend the scan to all the satellites
x
Define the following in the Scan Mode screen:
Scan Mode: Scan the Transponder database (Default) or by a Blind-scan (Blind-Detail)
1.
Programme: Choose Free Only to scan only free channels (recommended) or All for coded channels as
2.
well
x
Press OK to start scan
3.2.1.2.3 Motor Mode
This receiver can command a motorised antenna either manually (using the DiSEqC 1.2 protocol) or semi-
automatically (using the USALS protocol), depending on the type of motor used in the plant.
To use this mode, it is necessary to set the Switch Type parameter to DiSEqC 1.2/USALS.
Then use the following colored function buttons to define the following:
Set Limit (RED button): Define left/right rotation limits for the motor
1.
Set Location (GREEN button): Antenna plant's coordinates. Mandatory for USALS mode
2.
Set LNB (YELLOW button): Antenna converter. In Europe, the typical LNB Type is Universal
3.
Then, after having set the Position parameter for each protocol, press OK. The Edit screen will appear with
the following options listed for satellite association:
Satellite name: Select satellite name. Press the RED Add SAT button, select the satellite and press OK
1.
Move Step: Step adjustment of the antenna position
2.
Goto X: Goes to a position automatically (USALS only) or recalls the motor position saved earlier
3.
(DiSEqC 1.2)
Transponder: TP frequency on which to mount the antenna to receive the signal; Strength and Quality
4.
indicators are shown on screen. Use
available as a result of the previously selected satellite
x
Press OK to save settings and return to the previous screen
Satellite/s channels scan
To conduct a channel scan on selected satellites:
x
Press the BLUE Scan button to scan only the satellite selected
x
Define the following in the Scan Mode screen:
Scan Mode: Scan the Transponder database (Default) or by a Blind-scan (Blind-Detail)
1.
Programme: Choose Free Only to scan only free channels (recommended) or All for coded channels as
2.
well
x
Press OK to start scan
3.2.1.3 Transponder management and single channel search
The TP Manager menu allows you to modify and update the preset list of satellites and relative
transponders, as well as conduct a limited channel search on a single transponder.
Database management
Use:
x
/ to change satellite and
x
colored contextual functional buttons for each satellite or a transponder for updates/modifications
Transponder channels scan
To conduct a channels scan on a single frequency:
x
Press the BLUE Scan button on the selected transponder
x
Define the following in the Scan Mode screen:
Programme: Choose Free Only to scan only free channels (recommended) or All for coded channels as
1.
well
x
Press OK to start scan on selected frequency
CAUTION!
If the signal Strength (S) and Quality (Q) bars do not respond or indicate low levels, make sure the antenna has been
configured correctly in the My Dish menu and that the selected transponder is not out-of-date.
/ to choose a transponder from the list of transponders
/ to move between the selected satellite's transponders
TS3002
13