Drives Window; System Configuration Display; Drives Panel Display; Signals And Parameters Display - ABB DCS 600 Manual

Operation by PC (continued)

Drives Window

System Configuration Display

The System Configuration Display provides an
overview of the system as well as the type and status
of each product on the communication link(s). Included
in the System Configuration Display are previously
saved files located on the hard disk of the computer.
This display is built automatically by the Drives Window
tool by scanning the communication links to find the
configuration of the system.

Drives Panel Display

The Drives Panel Display is used for controlling the
operation of a selected drive within the system. You
can control different drives by changing the target
drive selection. The following commands are available
with the Drives Panel:
- Start and Stop
- Set the speed reference value
- Change the reference direction
- Reset the active fault
- Change to Local/Remote control mode

Signals and Parameters Display

The Signals and Parameters Display is used for
handling signals and parameters of the target drive.
The signal and parameter list is uploaded from the
drive and can be viewed, saved to a file or compared
to another parameter set. Previously saved values
can be downloaded to a matching drive. You can also
set the parameter values in either off-line or on-line
mode.
Monitor Display
The Monitoring Display is used for monitoring
graphically the actual values of the target. The following
functions are also supported:
- Zoom-in and Zoom-out
- Scaling the graphs
- Setting the sampling interval
- Setting the time window
II F 2-14
Fig. 2.5/9: Display of Drives Window
- Triggering on specific conditions
- Signals from multiple drives can be displayed in
the same view
Data Logger Display
The Data Logger Display provides facilities for viewing
the contents of the data loggers in the drive. You can
display the data in either graphical or numerical form
as well as setting-up the data logger triggering
conditions.
Event Logger Display
The contents of the Event Logger can be viewed and
cleared by using this display.
Fault Logger Display
The contents of the Fault Logger can be viewed and
cleared by using this display.
Application Display
Application programs can be downloaded and
debugged with this display.
Please note