Water Filter Installation - Nu-Vu NVT-3/9 Service And Repair Manual

WATER FILTER INSTALLATION

1. Attach water filter bracket to the rear of the unit using the 10-32 screws included with the filter
assembly.
2. Run 1/4" OD tubing from the water supply line to the unit location. Allow some slack in the
tubing for final unit positioning and any future service requirements. Avoid any kinks or strains
on the tubing, and position the tubing where it will not be damaged in any way.
3. The tubing end that attaches to the back of the unit and filter must not be damaged or
deformed in any way. The cut end should be cut straight and clean with no deforming of the
tubing. All burrs and sharp or rough edges should be removed to ensure a proper and leak-
free connection.
4. Position the tubing so that it runs straight into the intake Water Fitting on the rear of the unit.
Be careful not to kink the tubing if you bend it, and do not bend the tubing within two (2) inches
of the cut end.
5. Push the end of the tubing all the way into the intake Water Fitting (approximately 3/8").
®
NU-VU FOOD SERVICE SYSTEMS
4
page
Water Filter Installation
Drawing 4
Sales Fax (906) 863-5889 ♦ Service Fax (906) 863-6322
NVT-3/9 SERVICE AND REPAIR MANUAL
MENOMINEE, MICHIGAN 49858-0035
(800) 338-9886