Receipt And Installation - Nu-Vu RM-4T Owner's Manual

Hide thumbs

Table Of Contents

Table of Contents

RM/RA SERIES OWNER'S MANUAL

 Insufficient or incorrect voltage

 Damage to electrical components caused by a power surge or spike

 Incorrect installation (i.e., separate neutral and ground not supplied, or incorrect

location of high-voltage power leg for 240-volt 3-phase units)

 Damage to electrical components resulting from use of an incorrect power supply

cord or circuit breaker

•

Operational problems resulting from customer's failure to follow established procedures

outlined in the Owner's Manual.

•

A service call if nothing wrong is found (parts still work per spec when tested).

•

Recalibration of temperature and humidity controls (all controls are carefully calibrated

and tested at our facility before shipment).

•

Any equipment moved from the place of original installation unless NVUV® agrees in

writing to continue the warranty after the relocation.

•

Ongoing operational adjustments due to changing environmental conditions or normal

wear and tear.

•

Any overtime charges. NUVU® will pay straight time only for any work performed on

NUVU® equipment.

Food service equipment and parts must be installed and maintained in accordance with NUVU®

instructions. Users are responsible for the suitability of the units or parts to their application. There

is no warranty against damage resulting from accident, abuse, alteration, misapplication,

inadequate storage prior to installation, or improper specification or other operating conditions

beyond our control. Claims against carrier's damage in transit must be filed by the buyer and,

therefore, the buyer must inspect the product immediately upon receipt.

THIS WARRANTY DOES NOT COVER ADJUSTMENTS

PARTS RETURN PROCEDURES AND CONDITIONS:

The following procedure shall be followed for the return of parts to the factory for credit

consideration:

•

All parts received by NVUV® must have a completed Return Authorization Form as

supplied by NUVU® with the part. Complete and return this Authorization Form with

the defective part(s).

•

Parts MUST be packed securely so that in-transit damage cannot occur.

•

Prepay shipment. Any parts returned collect will be refused by our Receiving

Department. Credit will be issued on proper returns only.

•

As soon as parts are tested and confirmed as defective, credit will be issued against them.

•

If the engineering test shows the component is not defective and in good working

condition, it may be returned to you along with your request for payment.