Video Section Adjustments; Preparations Before Adjustments; Equipment Required - Sony DCR-PC101E Service Manual

5-3. VIDEO SECTION ADJUSTMENTS

NTSC model : DCR-PC101
PAL model : DCR-PC101E
3-1.

PREPARATIONS BEFORE ADJUSTMENTS

Use the following measuring instruments for video section adjust-
ments.
3-1-1.

Equipment Required

1) TV monitor
2) Oscilloscope (dual-phenomenon, band above 30 MHz with
delay mode) (Unless specified otherwise, use a 10 : 1 probe.)
3) Frequency counter
4) Pattern generator with video output terminal.
5) Digital voltmeter
6) Audio generator
7) Audio level meter
8) Audio distortion meter
9) Audio attenuator
10) Regulated power supply
11) Alignment tapes
• Tracking standard (XH2-1)
Parts code: 8-967-997-01
• SW/OL standard (XH2-3)
Parts code: 8-967-997-11
• Audio operation check for NTSC (XH5-3)
Parts code: 8-967-997-51
• System operation check for NTSC (XH5-5)
Parts code: 8-967-997-61
• Audio operation check for PAL (XH5-3P)
Parts code: 8-967-997-55
• System operation check for PAL (XH5-5P)
Parts code: 8-967-997-66
12) Adjustment remote commander (J-6082-053-B)
13) CPC-6 flexible jig (J-6082-370-B) (Note)
14) CPC-6 terminal board jig (J-6082-371-A)
Note: The CPC-6 jig (J-6082-370-A) is also usable.
5-43
DCR-PC101/PC101E