Monoprice maker architect 13861 User Manual page 27

32. Click the Generate GCode button in the gray box on the right.
33. Change the Slicing Profile to Replicator 2 slicing defaults using the drop down list
box.
34. If your model has portions that hang over empty
spaces in the model or over the build platform, you
will want to use the Support option. Additionally, if
your model has a small contact area with the build
platform, you will want to use the Raft option. The
selected model (20mm Calibration Box) has no
overhanging elements and has sufficient contact area,
so deselect the Use Raft/Support option.
35. If you are using Support for overhanging elements on
your model, set the Use support material option to
either Exterior support or Full support. The Exterior
option creates support only for those parts of the
model that are over the build platform, as seen in the
red model, while the Full option creates
support for any overhanging element, as seen
in the green model. For this model we need no
support, so set the Use support material option
to None.
27