AEG AR 4030 BT/USB/CR Instruction Manual page 47

2. When installing/connecting your device please note that
not every vehicle is equipped with an "ISO connection".
In this case we recommend the use of an ISO adapter
specifically designed for your vehicle.
Adapters are available from car accessory shops and / or
from your vehicle workshop.
3. Depending on the specific car type, different wiring
connection of the "Duration +" wire (Constant current
connection) are available. (However, this is necessary for
storing the radio stations).
In order to guarantee all functions, installation in line with
these instructions is essential. In cases of doubt please
contact an authorised car workshop.
Due to the various types of motor vehicles and motor
manufacturers, it is not possible to guarantee that the pin
assignment of the ISO plug is correct, even if the ISO plug
connections fit together mechanically. It may therefore
be necessary to modify the electrical connection or use
vehicle-specific adapters.
NOTE:
If the device is correctly connected, the radio can be
switched on and off via the ignition. If the stored stations
are lost, this indicates that the radio is not receiving any
"continuous +", current which is required for storing the
stations.
CAUTION:
Where there is a connection to "continuous +" without
the ignition being switched on, the car battery might be
drained of power even if the radio is switched off. This
may even result in the battery becoming completely flat.
4. Depending on the specific car type, interferences may
arise during operation. These interferences can avoided
easily with an additional Interferences filter. Your car
radio is originally prepared with an Interference Filter
already.
In these case, please contact your authorized car dealer.
5. When installing your radio please ensure that there is
enough space at the rear of the radio to ensure sufficient
cooling.
6. For the antenna connection there are two different norms.
The first of these is the old (50 ohm) version with a long
protruding round contact on the vehicle and a round
socket on the radio end. The second is the ISO-standard-
ised antenna plug (150 ohm). Adapters for both formats
are available from accessory manufacturers and / or your
car workshop.
AR4030BT-USB-CR_IM
NOTE:
Important information for VW / Audi vehicles: Your car
may have an active antenna. It requires a power supply
as it is provided only by original car radios. In this case,
use a phantom-powered antenna adapter.
Antenna adapters are available at car accessory suppli-
ers and / or your automotive workshop.
Installation
Please install the car radio as shown below.
a Slide-in housing
b Extraction tool (spanner for dismantling)
English
47
05.07.16