P2P; Figure 5-10 P2P Configuration Interface; Table 5-8 P2P Configurations - Honeywell H2W2PRV3 Software Configuration Manual

Performance Series IP Camera Software Configuration Guide
Parameter
Alternate DNS Server
Enable ARP/Ping to
set IP Address Service

P2P

Figure 5-10 P2P Configuration Interface

Table 5-8 P2P Configurations

Parameter Function
Enable Click the checkbox if you want to access the camera using the HonView Touch app.
Status Displays the connection status of the camera.
S/N
Displays the serial number of the camera.
If you have the HonView Touch app installed on a mobile device, you can scan this QR
QR Code code to add the camera. You can then view live video or configure the camera with the
app.
32
Function
Enter an alternate DNS server IP address.
If you know the camera's MAC address, then use the ARP/Ping command
to modify or set the camera's IP address.
Before operating the camera, please ensure that the network camera
and the PC are in the same LAN. This function is On by default.
To enable ARP/Ping to set the IP address service:
1. Get an IP address. Set up the network camera and the PC in the
same LAN.
2. Get the physical address from the label on the network camera.
3. Open the Run interface (Start menu > Run), and then type the
following commands:
arp -s <IP Address> <MAC> ping -l 480 -t
<IP Address>
For example:
arp -s 192.168.0.125 11-40-8c-18-10-11 ping -l 480 -t
192.168.0.125
4. Reboot the camera. If the setup was successful, output information
such as Reply from 192.168.0.125... will appear in the command
output lines.
5. Close the command line.
Open your browser, type http://<IP address> in the address bar, and
then press Enter